Introduction to cleaning method of cup printing machine

The cup printing machine has small problems with daily operation. At ordinary times, the operator or mechanical maintenance personnel should pay attention to the cleaning and maintenance of the cup printing machine, so as to meet the quality requirements of the product, reduce the failure rate of the equipment and prolong the service life. Here are some cleaning methods for the main parts of the cup printing machine:

1. bucket cleaning: remove the paper scraps and impurities in the bucket. Do not splash the impurities in the bucket onto other parts. At the same time, carefully check whether the parts near the bucket are rusted or leaking, and whether the surface of the water shaft is clean. Cup printing machine

2. do not leave ink on the rubber roller and other parts during shutdown, and do not dry the ink on it. Clean it in time when it is found, otherwise the ink film will damage the rubber roller. If the cup printing machine is not used for three days, remove the rubber roller from it, wipe it clean and put it away, so as to avoid extrusion deformation. 3. track cleaning: for example, the track is easy to accumulate paper dust and spray powder. After cleaning, add engine oil to keep the track clean, and clean the chain and conveyor belt on the track. 4. the gear of the cup printing machine is easy to stick with grease, paper ash, glue and other substances, so it should be cleaned regularly. Clean the oil tank, check the oil concentration and impurities, change the oil regularly, and clean the filter. 5. for the cleaning of bearings, dental discs, dental pads, etc., especially the bearings at both ends of the rubber roller, avoid the obstruction of bearing rotation caused by the condensation of ink and glue. The dental tablets and dental pads should be cleaned regularly with a brush until the surface shows reticulate lines. Clean all parts of the cup printer regularly to keep the whole equipment clean and the ground clean at the same time